Description
Introducing our 10,000 lbs Car Lift L1100 2 Post Overhead Car Auto Truck Hoist, available in both 220V and 110V options. This robust lift provides reliable lifting power for vehicles up to 10,000 lbs. With its sturdy construction and versatile design, it’s the ideal solution for automotive workshops. Upgrade your lifting capabilities with this efficient and durable car lift L1100 and experience the convenience of effortless vehicle maintenance and repairs.
Car Lift L1100 Features:
Safety Mechanism:
- Double Point Safety Lock Release
- Automatic arm lock restraints
- Relief valve built in power pump to prevent overloading
- Door guards protection rubber
- Up-limit switch to protect cylinders working stroke used in safe length scope
- Heavy duty 5/16″ diameter cable and 4.56″ pulley reduce high stress on synchronization process and increase cable life
- Stiffened base plate 5/8″ thickness
- Ultra high molecular self lubricating nylon slider ensures carriage smooth moving up and down
- Anchor bolts/mounting hardware included
Control System:
- Lifting operation by pressing “UP” button on motor
- Manual lowering operation by pressing lever
- Relief valve built in power pump to prevent overloading
- 1 sets truck adapters included
- Lifting Capacity: 10,000 lbs
- The overall Height 145-5/8″
- The overall Width 133-1/4″
- Column Width 10.62″
- Base Width 18.89″
- Column Thickness of Steel 3/16″
- Carriage Thickness of Steel 15/64″
- Arms Thickness of Steel 15/64″
- Front Arm 30.7″ to 48
- Rear Arm 30.7″ to 48″
- Min pad height: 3-7/8″
- Lift height max: 78-7/8″
- Drive-thru width clearance: 100″
- Time to full rise: 20-60 sec
- Shipping Weight: 1460 lbs
Site Selection:
Before installing your auto lift, check the following:
- Lift Location: Always use architect’s plans when available.
- Check layout dimension against floor plan requirements making sure adequate space is available.
- Your lift requires a 220v, 30amp, single phase, grounded electrical source. There should be room enough to operate the lift in a safe manner and without restrictions.
- Overhead Area: The area where the lift will be located should be free of overhead obstructions such as heaters, building supports, electrical lines, doors, lights, etc.
- Floor Area: Visually inspect the site where the lift is to be installed and check for cracked or defective concrete.
Floor Requirements:
- A level floor is suggested for proper installation and level lifting. Small differences in floor slopes may be compensated for by proper shimming. If a floor is of questionable slope, consider a survey of the site and/or the possibility of pouring a new level concrete slab.
- New concrete must be adequately cured for at least 30 days.
-
DO NOT install auto lift on any asphalt surface or any surface other than concrete.
-
DO NOT install auto lift on expansion seams or on cracked or defective concrete.
-
DO NOT install auto lift on a second/elevated floor without first consulting building architect.
- DO NOT install auto lift outdoors unless special consideration has been made to protect the power unit from inclement weather conditions.
Concrete Specifications:
All models MUST be installed on 3,000 PSI reinforced concrete only. Additional concrete requirements will vary by lift.
- 8,500 lbs – 10,000 lbs lifts: 4″ Minimum Thickness
- 11,000 lbs – 15,000 lbs lifts: 6″ Minimum Thickness
specifications:
- Condition: New
- Modified Item: No
- Custom Bundle: No
- Material: Metal
- Capacity: 10000lbs.
- Type: 2-Post Lift
- Features: Hydraulic
- Vehicle Type: Passenger Vehicle
- Brand: XINKONG
- Non-Domestic Product: No